Struct cortex_m::peripheral::NVIC

pub struct NVIC { /* fields omitted */ }

Nested Vector Interrupt Controller

Implementations

impl NVIC

pub fn request<I>(&mut self, interrupt: I) where
    I: Nr, 

Request an IRQ in software

Writing a value to the INTID field is the same as manually pending an interrupt by setting the corresponding interrupt bit in an Interrupt Set Pending Register. This is similar to set_pending.

This method is not available on ARMv6-M chips.

pub fn clear_pending<I>(&mut self, interrupt: I) where
    I: Nr, 

👎 Deprecated since 0.5.8:

Use NVIC::unpend

Clears interrupt's pending state

pub fn mask<I>(interrupt: I) where
    I: Nr, 

Disables interrupt

pub unsafe fn unmask<I>(interrupt: I) where
    I: Nr, 

Enables interrupt

This function is unsafe because it can break mask-based critical sections

pub fn disable<I>(&mut self, interrupt: I) where
    I: Nr, 

👎 Deprecated since 0.6.1:

Use NVIC::mask

Disables interrupt

pub fn enable<I>(&mut self, interrupt: I) where
    I: Nr, 

👎 Deprecated since 0.6.1:

Use NVIC::unmask

WARNING This method is a soundness hole in the API; it should actually be an unsafe function. Use NVIC::unmask which has the right unsafety.

pub fn get_priority<I>(interrupt: I) -> u8 where
    I: Nr, 

Returns the NVIC priority of interrupt

NOTE NVIC encodes priority in the highest bits of a byte so values like 1 and 2 map to the same priority. Also for NVIC priorities, a lower value (e.g. 16) has higher priority (urgency) than a larger value (e.g. 32).

pub fn is_active<I>(interrupt: I) -> bool where
    I: Nr, 

Is interrupt active or pre-empted and stacked

pub fn is_enabled<I>(interrupt: I) -> bool where
    I: Nr, 

Checks if interrupt is enabled

pub fn is_pending<I>(interrupt: I) -> bool where
    I: Nr, 

Checks if interrupt is pending

pub fn pend<I>(interrupt: I) where
    I: Nr, 

Forces interrupt into pending state

pub fn set_pending<I>(&mut self, interrupt: I) where
    I: Nr, 

👎 Deprecated since 0.5.8:

Use NVIC::pend

Forces interrupt into pending state

pub unsafe fn set_priority<I>(&mut self, interrupt: I, prio: u8) where
    I: Nr, 

Sets the "priority" of interrupt to prio

NOTE See get_priority method for an explanation of how NVIC priorities work.

On ARMv6-M, updating an interrupt priority requires a read-modify-write operation. On ARMv7-M, the operation is performed in a single atomic write operation.

Unsafety

Changing priority levels can break priority-based critical sections (see register::basepri) and compromise memory safety.

pub fn unpend<I>(interrupt: I) where
    I: Nr, 

Clears interrupt's pending state

impl NVIC

pub fn ptr() -> *const RegisterBlock

Returns a pointer to the register block

Trait Implementations

impl Deref for NVIC

type Target = RegisterBlock

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl Send for NVIC