Struct embassy_stm32::usart::Config

#[non_exhaustive]
pub struct Config {
    pub baudrate: u32,
    pub data_bits: DataBits,
    pub stop_bits: StopBits,
    pub parity: Parity,
    pub detect_previous_overrun: bool,
    pub assume_noise_free: bool,
    pub swap_rx_tx: bool,
    pub invert_tx: bool,
    pub invert_rx: bool,
}

Config

Fields (Non-exhaustive)

Non-exhaustive structs could have additional fields added in future. Therefore, non-exhaustive structs cannot be constructed in external crates using the traditional Struct { .. } syntax; cannot be matched against without a wildcard ..; and struct update syntax will not work.

baudrate: u32

Baud rate

data_bits: DataBits

Number of data bits

stop_bits: StopBits

Number of stop bits

parity: Parity

Parity type

detect_previous_overrun: bool

If true: on a read-like method, if there is a latent error pending, the read will abort and the error will be reported and cleared

If false: the error is ignored and cleared

assume_noise_free: bool

Set this to true if the line is considered noise free. This will increase the receiver’s tolerance to clock deviations, but will effectively disable noise detection.

swap_rx_tx: bool

Set this to true to swap the RX and TX pins.

invert_tx: bool

Set this to true to invert TX pin signal values (V_DD =0/mark, Gnd = 1/idle).

invert_rx: bool

Set this to true to invert RX pin signal values (V_DD =0/mark, Gnd = 1/idle).

Trait Implementations

impl Clone for Config

fn clone(&self) -> Config

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Config

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for Config

fn default() -> Self

Returns the “default value” for a type.

impl PartialEq for Config

fn eq(&self, other: &Config) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Config

impl Eq for Config

impl StructuralEq for Config

impl StructuralPartialEq for Config