Trait esp32c2_hal::gpio::OutputPin

pub trait OutputPin: Pin {
    // Required methods
    fn set_to_open_drain_output(&mut self) -> &mut Self;
    fn set_to_push_pull_output(&mut self) -> &mut Self;
    fn enable_output(&mut self, on: bool) -> &mut Self;
    fn set_output_high(&mut self, on: bool) -> &mut Self;
    fn set_drive_strength(&mut self, strength: DriveStrength) -> &mut Self;
    fn enable_open_drain(&mut self, on: bool) -> &mut Self;
    fn enable_output_in_sleep_mode(&mut self, on: bool) -> &mut Self;
    fn internal_pull_up_in_sleep_mode(&mut self, on: bool) -> &mut Self;
    fn internal_pull_down_in_sleep_mode(&mut self, on: bool) -> &mut Self;
    fn connect_peripheral_to_output_with_options(
        &mut self,
        signal: OutputSignal,
        invert: bool,
        invert_enable: bool,
        enable_from_gpio: bool,
        force_via_gpio_mux: bool
    ) -> &mut Self;
    fn disconnect_peripheral_from_output(&mut self) -> &mut Self;
    fn internal_pull_up(&mut self, on: bool) -> &mut Self;
    fn internal_pull_down(&mut self, on: bool) -> &mut Self;

    // Provided method
    fn connect_peripheral_to_output(&mut self, signal: OutputSignal) -> &mut Self { ... }
}

Required Methods

fn set_to_open_drain_output(&mut self) -> &mut Self

fn set_to_push_pull_output(&mut self) -> &mut Self

fn enable_output(&mut self, on: bool) -> &mut Self

fn set_output_high(&mut self, on: bool) -> &mut Self

fn set_drive_strength(&mut self, strength: DriveStrength) -> &mut Self

fn enable_open_drain(&mut self, on: bool) -> &mut Self

fn enable_output_in_sleep_mode(&mut self, on: bool) -> &mut Self

fn internal_pull_up_in_sleep_mode(&mut self, on: bool) -> &mut Self

fn internal_pull_down_in_sleep_mode(&mut self, on: bool) -> &mut Self

fn connect_peripheral_to_output_with_options( &mut self, signal: OutputSignal, invert: bool, invert_enable: bool, enable_from_gpio: bool, force_via_gpio_mux: bool ) -> &mut Self

fn disconnect_peripheral_from_output(&mut self) -> &mut Self

Remove this output pin from a connected signal.

Clears the entry in the GPIO matrix / IO mux that associates this output pin with a previously connected signal. Any other outputs connected to the signal remain intact.

fn internal_pull_up(&mut self, on: bool) -> &mut Self

fn internal_pull_down(&mut self, on: bool) -> &mut Self

Provided Methods

fn connect_peripheral_to_output(&mut self, signal: OutputSignal) -> &mut Self

Implementors

impl<MODE, RA, IRA, PINTYPE, SIG, const GPIONUM: u8> OutputPin for GpioPin<MODE, RA, IRA, PINTYPE, SIG, GPIONUM>where RA: BankGpioRegisterAccess, IRA: InteruptStatusRegisterAccess, PINTYPE: IsOutputPin, SIG: GpioSignal,