pub struct ZxdgSurfaceV6(_);

Implementations

suggest a surface change

The configure event marks the end of a configure sequence. A configure sequence is a set of one or more events configuring the state of the xdg_surface, including the final xdg_surface.configure event.

Where applicable, xdg_surface surface roles will during a configure sequence extend this event as a latched state sent as events before the xdg_surface.configure event. Such events should be considered to make up a set of atomically applied configuration states, where the xdg_surface.configure commits the accumulated state.

Clients should arrange their surface for the new states, and then send an ack_configure request with the serial sent in this configure event at some point before committing the new surface.

If the client receives multiple configure events before it can respond to one, it is free to discard all but the last event it received.

Trait Implementations

Converts this type into a shared reference of the (usually inferred) input type.

Returns a copy of the value. Read more

Performs copy-assignment from source. Read more

Formats the value using the given formatter. Read more

Converts to this type from the input type.

Converts to this type from the input type.

Set of requests associated to this interface Read more

Set of events associated to this interface Read more

Name of this interface

Maximum supported version of this interface Read more

Pointer to the C representation of this interface

This method tests for self and other values to be equal, and is used by ==. Read more

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason. Read more

Auto Trait Implementations

Blanket Implementations

Gets the TypeId of self. Read more

Immutably borrows from an owned value. Read more

Mutably borrows from an owned value. Read more

Convert Box<dyn Trait> (where Trait: Downcast) to Box<dyn Any>. Box<dyn Any> can then be further downcast into Box<ConcreteType> where ConcreteType implements Trait. Read more

Convert Rc<Trait> (where Trait: Downcast) to Rc<Any>. Rc<Any> can then be further downcast into Rc<ConcreteType> where ConcreteType implements Trait. Read more

Convert &Trait (where Trait: Downcast) to &Any. This is needed since Rust cannot generate &Any’s vtable from &Trait’s. Read more

Convert &mut Trait (where Trait: Downcast) to &Any. This is needed since Rust cannot generate &mut Any’s vtable from &mut Trait’s. Read more

Convert Arc<Trait> (where Trait: Downcast) to Arc<Any>. Arc<Any> can then be further downcast into Arc<ConcreteType> where ConcreteType implements Trait. Read more

Returns the argument unchanged.

Calls U::from(self).

That is, this conversion is whatever the implementation of From<T> for U chooses to do.

The resulting type after obtaining ownership.

Creates owned data from borrowed data, usually by cloning. Read more

Uses borrowed data to replace owned data, usually by cloning. Read more

The type returned in the event of a conversion error.

Performs the conversion.

The type returned in the event of a conversion error.

Performs the conversion.