Struct embassy_boot::BootLoaderConfig

pub struct BootLoaderConfig<ACTIVE, DFU, STATE> {
    pub active: ACTIVE,
    pub dfu: DFU,
    pub state: STATE,
}

Bootloader flash configuration holding the three flashes used by the bootloader

If only a single flash is actually used, then that flash should be partitioned into three partitions before use. The easiest way to do this is to use BootLoaderConfig::from_linkerfile_blocking which will partition the provided flash according to symbols defined in the linkerfile.

Fields

active: ACTIVE

Flash type used for the active partition - the partition which will be booted from.

dfu: DFU

Flash type used for the dfu partition - the partition which will be swapped in when requested.

state: STATE

Flash type used for the state partition.

Implementations

impl<'a, FLASH: NorFlash> BootLoaderConfig<BlockingPartition<'a, NoopRawMutex, FLASH>, BlockingPartition<'a, NoopRawMutex, FLASH>, BlockingPartition<'a, NoopRawMutex, FLASH>>

pub fn from_linkerfile_blocking( flash: &'a Mutex<NoopRawMutex, RefCell<FLASH>> ) -> Self

Create a bootloader config from the flash and address symbols defined in the linkerfile